SHARP HTCN400DVE
Instrukcja Obsługi

Battery installation
Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar). Batteries are not included.

Turning the power on
! Test of the remote control
Check the remote control operation after making all the connections (see pages 14 17). Point the remote control directly at the remote sensor on the unit.

HT-CN400DVE HT-CN500DVE

1 Open the battery cover. 2 Insert the batteries according to the direction indicated in the battery compartment. 3 Close the cover.
When inserting or removing the batteries, push them towards the nals. battery termi-

The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your system.

Remote sensor

4
0.2 m - 6 m (8" - 20')

OPEN/ CLOSE

SET UP

MUTE

ON/ STAND-BY

TITLE

SUBTITLE LANGUAGE DISPLAY

ON/ STAND-BY

MENU/PBC

ST/MO

Precautions for battery use:
" Replace all old batteries with new ones at the same time. " Do not mix old and new batteries. " Remove the batteries if the unit is not to be used for long periods of time. This will prevent potential damage due to battery leakage.

ENTER

! To turn the power on

Caution:
" Do not use rechargeable batteries (nickel-cadmium battery, etc.). " Incorrect installation may cause the unit to malfunction.

Preparation for Use
19
92LCN500U0270 Battery installation / Turning the power on -

SHARP 92LCN500U0270 (UK)

Notes concerning use:

" Replace the batteries if the operating distance is reduced or if the operation becomes erratic. " Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. " Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit. " Keep the remote control away from moisture, heat, shock, and vibrations.

Power stand-by indicator

Press the ON/STAND-BY button.
If the power does not turn on, check the AC power lead is plugged in properly.

To set the unit to the stand-by mode:
Press the ON/STAND-BY button again. The power stand-by indicator lights up.

03/6/27

HTCN400_500DVE(E)2.fm