WHEN THE �OVER LEVEL� INDICATOR LIGHTS UP
When input analog signals from the connected equipment are too high to accept, the OVER LEVEL indicator lights up. In this case, adjust the input level so that the indicator disappears.
RECORDING AN AUDIO SOURCE
FUNCTION
FUNCTION
To lower the sound level of the connected source
1 Select the function to be adjusted.
Turn FUNCTION and play the source.
2 Press TUNING M repeatedly.
The level is decreased as follows.
0 dB �6 dB �12 dB
INPUT MODE
To restore the previous level, press
TUNING N repeatedly .
1 Select the program source to be recorded.
� When the analog output of the CD player or DVD player is 2 Vrms, set the level to �6 dB. Turn FUNCTION (or press FUNCTION repeatedly).
2 Set the tape deck or MD recorder to recording mode. 3 Start the selected program source.
NOTE � Any sound control system has no ef fect on recording (see page 9). � Input sound through the DIGIT AL IN terminals cannot be recorded. When recording the sound from the DVD, CD, MD or LD player , connect the analog AUDIO OUT terminals of the player to the corresponding AUDIO IN terminals of the receiver . The sound will be recorded in 2 ch stereo. � Input sound from the tape deck connected to the TAPE IN terminals cannot be recorded.
En
ENGLISH
11
BASIC OPERATIONS
When the analog sound level of the connected source is higher than that of the FM and AM functions, adjust it as follows.
