PIONEER HTP-4600/KUCXCN
Skrócona Instrukcja Obsługi

HTP-4600 Quick Start Guide

1

Check that you have all the accessories.
Insert the supplied batteries following the markings inside the battery compartment to align them correctly.
�
SYSTEM SETUP STANDBY/ON SLEEP STATUS MUTE DIMMER
TUNER EDIT

2

Connect wireless speaker transmitter. 1
Use the supplied 2-pin RCA cord to connect the WIRELESS (IN) jack on the transmitter to the WIRELESS (OUT) jack on the rear panel of the receiver.

3

Connect each speaker to the receiver using the supplied speaker wires.
To connect, insert the colored wire into the matching colored (+) tab and the other wire into the black (�) tab as shown below. Note that the color-coded tabs are as follows:
� Red : Front right speaker � White : Front left speaker � Green : Center speaker � Purple : Subwoofer � Grey : Surround right speaker � Blue : Surround left speaker

Surround right

Wireless speaker

Surround left

INPUT SELECTOR DIGITAL STB DVD/DVR FM/AM TAPE/VCR TV

2

CLASS

Connect to a power outlet using the supplied AC adaptor.

� Please also read the Operating Instructions included with the wireless speaker.

TUNING

STATION

+ +
ENTER

�

+
CH LEVEL

VOLUME

ROOM SETUP

TEST TONE

IN

R

L

AC adaptor
IN R L

�
AUTO
OFF

SURROUND
SOUND TONE

STEREO MPX

WIRELESS

WIRELESS

Transmitter

Transmitter
�

BASS

+

�

TREBLE +

To power outlet

Receiver

Batteries (x2)

AM loop antenna FM wire antenna

RECEIVER

Remote control
R FRONT L CENTER WOOFER SUB SPEAKERS SURROUND R L

Listening position
+ � +
L WIRELESS OUT

Subwoofer

Receiver

�

R

You should also have: � Speakers* � Subwoofer � Non-skid pads (1x12) � Speaker cord (x6) � AC adaptor � Transmitter � Power cord � RCA stereo cord � Safety precautions (1 sheet)

� Operating instructions � Warranty card
L

WIRELESS OUT

R

* Before placing the speakers, please refer to the speaker manual for detailed assembly instructions. Also check the speaker manual for a complete list of supplied accessories.
R FRONT L

SPEAKERS CENTER SUB WOOFER

SURROUND R L

WIRELESS

+ �

+
L

OUT R

�

For the best surround sound, set up your speakers like this. The front left and right speakers should be about 6�9 feet apart.

Front right

Center

Front left

4
1 2

Connect antennas
Connect the FM wire antenna and fully extend along a window frame or another suitable place that gives good reception. To connect the AM loop antenna, twist the exposed wire strands together and insert into the terminal, then snap the connector shut as shown below.

5
1 2

Connect the receiver to your DVD player/ recorder.

6
1
Press

Use a coaxial digital cord (not supplied) to connect the digital output of your DVD player/ recorder to the DIGITAL INPUT (COAXIAL) DVD/DVR jack. Use a red/white stereo audio cord (not supplied) to connect the AUDIO TV IN jack on the receiver to the audio output on your

Plug the receiver, wireless speaker, DVD player/ recorder and TV into a convenient AC outlet.
STANDBY/ON to switch on the receiver.

7

After switching on, make any necessary settings required by the DVD player/ recorder, then you're ready to start enjoying your home theater system.
Refer to the receiver's operating instructions for a detailed explanation of this system's surround sound features.

STANDBY/ON

TV.* This will allow you to listen to your TV through this speaker system. * Note that you must also connect the DVD player/ recorder's
STANDBY/ON
VOLUME AUTO SURROUND STEREO
INPUT SELECTOR DIGITAL STB DVD/DVR

AM loop antenna

video output to your TV's video input to watch a DVD video (video cable is not supplied).

+

Receiver

FM/AM TAPE/VCR

TV

�

DIGITAL INPUT (COAXIAL) DVD/DVR

2
Press to switch the wireless speaker on.

FM wire antenna
Receiver
TV IN IN AUDIO

+

+

TUNED

POWER
OFF ON

ANTENNA
OUT R L

�

�

FM UNBAL 75� AM LOOP

POWER

Wireless speaker

OFF

ON

Receiver

3
R VIDEO IN AUDIO OUT L

Switch on your DVD player/ recorder and TV, and set the TV to the correct video input.
VIDEO 1

TV

3/8 in. (10mm)
DVD player/ recorder

DIGITAL OUT

VIDEO OUT

STANDBY/ON

STANDBY/ON

VIDEO SELECT

DVD player/ recorder

TV

For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404.