HTP-490 Quick Start Guide
1
Check that you have all the accessories.
Speaker cable x6 �Red �White �Grey �Blue �Green �Purple
RECEIVER SLEEP DIMMER ANALOG ATT
INPUT SELECTOR
2
DVD
F.AUDIO
Put the batteries in the remote control and stick the non-skid pads to the base of the speakers.
3
1
Assemble the speaker stands and secure your front and surround speakers.
4
1
Connect antennas.
TV CD-R
DVR FM
RECEIVER
CD
AM
MIDNIGHT/ STANDARD ADV.SURR STEREO LOUDNESS
TOP MENU
MENU
SETUP
DIALOG E
ENTER
TUNER EDIT
ONE TOUCH COPY
Attach the speaker stand bases to the stems using the screws provided. Once you have aligned the stem and base, secure with the small screws at the points shown below.
Connect the FM wire antenna and fully extend along a window frame or another suitable place that receives good reception.
S.RETRIEVER
RETURN
2
VOLUME
EFFECT/CH SEL LEVEL MUTE
To connect the AM loop antenna, twist the exposed wire strands together and insert into the terminal, then snap the connector shut as shown below.
DVD/DVR
HDD
DVD
SUBTITLE
CH
GUIDE REC
CH
AUDIO
FM wire antenna Batteries x2 (to confirm system operation) AM loop antenna
TIMER REC
INFO
REC STOP
JUKEBOX
DISPLAY
CLASS
DVD/DVR
TUNING STATION
SHIFT
MPX
TUNER
Rear
RECEIVER
Remote control
Screws (for bases) x12 Please see the speaker manual for detailed instructions on the setup Speaker stand bases x4 and use of the speaker stands and accessories (screws, etc.).
Note � When disposing of used batteries, please comply with governmental and/or environmental regulations that apply in your country or area. � Do not use or store batteries in direct sunlight or other excessively hot places, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. Stick the self-adhesive non-skid pads to the underside of each speaker, and to the underside of the subwoofer. Use four pads per speaker (see below).
AM loop antenna
Front
FM wire antenna
2
To ensure stability, secure each of the front and surround speakers using the plastic catch provided. Screw two picture hooks or similar into the wall behind the speaker. Pass a cord around the hooks and through the plastic catch so that the speaker is stabilized (make sure to test that it supports the weight of the speaker). After installing, make sure the speaker is securely fixed.
Receiver
FM UNBAL 75 � AM LOOP ANTENNA
OPT CD DIGITAL IN COAX COAX
DVD/LD DVR
Large non-skid pads (for speaker stand bases) x16
IN IN OUT
TV / SAT CD-R / TAPE / MD
S P E A K E R S
R
FRONT
R
AUDIO
L
Large non-skid pads (for subwoofer) x4 Small non-skid pads (for center speaker) x4
You should also have: � Speakers (x5) � Subwoofer � Operating instructions � Mini plug audio cable
Front and Surround speakers Center speaker Subwoofer
Sufficiently thick cord (not supplied)
Caution
Plastic catch
� The plastic catch is not a mounting fixture, therefore the speaker cannot be hung from the wall using this catch. � Pioneer disclaims all responsibility for any losses or damage resulting from improper assembly, installation, insufficient strength of the installation materials or misuse.
10 mm (3/8 in. )
5
1 2
Connect your DVD player/recorder (optional-not supplied) to the receiver.
6
1
Press
Use a coaxial digital cord (not supplied) to connect the digital output of your DVD player/recorder to the DIGITAL INPUT (COAXIAL) DVD/DVR jack. Use a red/white stereo audio cord (not supplied) to connect the AUDIO TV IN jack on the receiver to the audio output on your TV.* This will allow you to listen to your TV through this speaker system. * Note that you must also connect the DVD player/recorder�s video output to your TV�s video input to watch a DVD video (video cable is not supplied).
Receiver
FM UNBAL 75 � AM LOOP ANTENNA
Plug the receiver, DVD player/ recorder and TV into a convenient AC outlet.
STANDBY/ON to turn on the receiver.
7
Using the front panel audio input
Use the supplied mini-plug cable to connect an audio device (portable audio player, etc.) to the front panel audio input for playback through this system.
8
After turning on, make any necessary settings required by the DVD player/recorder, then you´re ready to start enjoying your home theater system.
Refer to the receiver�s operating instructions for a detailed explanation of this system�s surround sound features.
HDD DVD
AUDIO MULTI-CHANNEL RECEIVER
SX-218
MULTI JOG
ENTER
STANDARD
ADVANCED ST/DIRECT/ SURR AUTO SURR
DVD/LD
TV/SAT
DVR
CD
CD-R / TAPE / MD
FRONT AUDIO
FM
AM
TUNING
STATION
MPX
VSB MODE
DIALOGUE ENHANCEMENT
LISTENING MODE
DVD/DVR
DIMMER ANALOG ATT MIDNIGHT/ LOUDNESS SLEEP
SUBTITLE
MASTER VOLUME
STANDBY/ON
PHONES
MUTE TUNER EDIT QUICK SETUP
CH
TONE SETUP RETURN
CH
AUDIO
FRONT AUDIO INPUT
MULTI JOG
DOWN
UP
GUIDE
AUDIO MULTI-CHANNEL RECEIVER
REC
SX-218
MULTI JOG
STANDBY/ON
ENTER
Receiver
STANDARD ADVANCED ST/DIRECT/ SURR AUTO SURR DVD/LD TV / SAT DVR CD CD-R / TAPE / MD FRONT AUDIO FM AM TUNING STATION MPX VSB MODE DIALOGUE ENHANCEMENT
TIMER REC
LISTENING MODE
DIMMER ANALOG ATT MIDNIGHT/ LOUDNESS SLEEP
INFO
REC STOP
JUKEBOX
MASTER VOLUME
STANDBY/ON
OPT CD
2
IN TV / SAT CD-R / TAPE / MD IN
PHONES
MUTE
TUNER EDIT
TONE
QUICK SETUP
SETUP
RETURN
Turn on your DVD player/recorder and TV, and set the TV to the correct video input.
FRONT AUDIO INPUT
MULTI JOG
DOWN
UP
DIGITAL IN
COAX
DVR
COAX
DVD/LD
OUT
R
AUDIO
L
S P E A K E R S
R
FRONT
LR
SURROUND
L
CENTER
SUB WOOFER
VIDEO 1
STANDBY/ON
STANDBY/ON
VIDEO SELECT
DVD player/ recorder (Not supplied) TV
R VIDEO IN AUDIO OUT L
Mini plug audio cable
menu
TV
DIGITAL OUT
VIDEO OUT
DVD player/ recorder (Not supplied)
For detailed instructions, see the Operating Instructions supplied and/or contact one of our knowledgeable Pioneer Customer Service Representatives at 1-877-283-5901.
Setting Up Your HTP-490 Home Theater System At-a-Glance
Refer to the following diagram when making system connections for a full surround sound setup. Note that the TV, DVD player/recorder and some accessories are not included. Refer to the reverse side of this sheet to check what�s supplied with the HTP-490.
Wall mounting the center speaker
The center speaker has a mounting hole which can be used to mount the speaker on the wall.
Specifications
Amplifier section � Continuous power output
Front ............................ 100 W per channel* (200 Hz to 20 kHz, 0.7 %**, 8 �) Center .............................................. 100 W* (200 Hz to 20 kHz, 0.7 %**, 8 �) Surround ..................... 100 W per channel* (200 Hz to 20 kHz, 0.7 %**, 8 �) Subwoofer ........................................ 100 W* (45 Hz to 200 kHz, 0.7 %**, 8 �)
� RMS power output
Front ............................................ 144 W per channel (1 kHz, THD, 10 %, 8 �) Center .............................................................. 144 W (1 kHz, THD, 10 %, 8 �) Surround ..................................... 144 W per channel (1 kHz, THD, 10 %, 8 �) Subwoofer ........................................................ 144 W (1 kHz, THD, 10 %, 8 �)
5 mm to 7 mm (3/16 in. to 1/4 in.)
5 mm (3/16 in.) 10 mm (3/8 in.)
DVD player/ recorder
(Not supplied)
COAXIAL OUT
VIDEO OUT
� Music power output
Front ........................................... 167 W per channel (DIN MUSIC, 10 %, 8 �) Center ............................................................. 167 W (DIN MUSIC, 10 %, 8 �) Surround .................................... 167 W per channel (DIN MUSIC, 10 %, 8 �) Subwoofer ....................................................... 167 W (DIN MUSIC, 10 %, 8 �)
Before mounting (see above), keep in mind the following points:
� Remember that the speaker system is heavy and that its weight could cause the screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall you intend to mount the speakers on is strong enough to support them. Do not mount on plywood or soft surface walls. � Mounting screws are not supplied. Use screws that are suitable for the wall material and can support the weight of the speaker.
* Measured pursuant to the Federal Trade Commission�s Trade Regulation rule on Power Output Claims for Amplifiers. ** Measured by Audio Spectrum Analyzer.
Not supplied
Not supplied Not supplied
Caution
� If you are unsure of the qualities and strength of the walls, consult a professional for advice. � Pioneer is not responsible for any accidents or damage that result from improper installation. � Do not hang the front or surround speaker or subwoofer on the wall or from the ceiling as they might fall and cause injury. � When placing this unit, ensure that it is firmly secured and avoid areas where it may be likely to fall and cause injuly in the event of a natural disaster (such as an earthquake). For more information about speaker installation, please see the instructions that come with the speakers.
Connect each speaker to the receiver using the supplied speaker wires.
To connect, insert the colored wire into the matching positive (colored) terminal and the other wire into the negative (black) terminal as shown below. Connect the speakers the same way (matching the wire to the color-coded terminal). Note that the color-coded terminals are as follows:
� Red : Front right (R) � White : Front left (L) � Purple : Subwoofer � Grey : Surround right (R) � Blue : Surround left (L)
1
Twist and pull off the protective shields on each wire.
2
color-coded wire
AUDIO OUT VIDEO IN
TV
Front L.
(White)
Subwoofer
Front R.
(Red)
Receiver
� Green : Center speaker
�
FM UNBAL 75 � AM LOOP ANTENNA
+
�
+
Center
� +
�
+
(Green)
OPT CD
DIGITAL IN TV / SAT
COAX
DVR
IN
COAX
DVD/LD
IN
CD-R / TAPE / MD
S P E A K E R S
R
FRONT
LR
SURROUND
L
CENTER
SUB WOOFER
(Purple)
(Grey) (Blue)
OUT
R
AUDIO
L
� � +
+
The illustration above shows the connection for a DVD player (the DVD/LD jack). Connect to the DVR jack when connecting a DVD recorder.
Surround L.
Surround R.
For detailed instructions, see the Operating Instructions supplied and/or contact one of our knowledgeable Pioneer Customer Service Representatives at 1-877-283-5901.
<XRE3206-A> En
