JVC HX-Z1
Instrukcja Obsługi

Common Operations
Turning On or Off the Power
To turn on the unit, press (or STANDBY/ON on the remote control) so that the lamp on the button goes off.

Continued

Setting the Clock
You can set the clock whether the unit is on or off; however, if Ecology Mode is activated, you cannot set the clock while the unit is off. �0:00� flashes on the display until you set the clock.

On the unit ONLY:

1
To turn off the unit (on standby), press (or STANDBY/ON on the remote control) again so that the lamp on the button lights up. � A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to �0:00� right away, while the tuner preset stations (see page 13) will be erased in a few days.

Press CLOCK/TIMER.
The hour digits start flashing on the display.

CLOCK / TIMER

2

Turn 4 / ¢ to adjust the hour, then press SET/DISPLAY.
The minute digits start flashing on the display.

PRESET

Saving the Power Consumption while on Standby �Ecology Mode
You can save the power consumption while the unit is turned off (on standby). � You can set Ecology Mode whether the unit is on or off.

SET /

If you want to correct the hour

CANCEL / DEMO

DISPLAY

after pressing SET/DISPLAY, press CANCEL/DEMO. The hour digits start flashing again.

3

On the unit ONLY:
To activate the Ecology Mode, press ECO. ECO �ECO� appears on the display for 2 seconds (and demonstration is canceled temporarily if you have pressed the button while the unit is off). � Each time you press the button, �ECO� and �NORMAL� appear alternately on the display. To deactivate the Ecology Mode, press ECO again. �NORMAL� appears (and demonstration starts if the unit is turned off).

Turn 4 / ¢ to adjust the minute, then press SET/DISPLAY.

To check the clock time
Press and hold SET/DISPLAY while playing any source. � Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again
When you turn off the unit with Ecology Mode activated �ECO� flashes on the display, and the clock time will not be shown while the unit is turned off.

If you have set the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected. � Each time you press the button, the clock/timer setting modes change as follows:
DAILY Canceled TIMER
(Daily Timer setting)

REC TIMER
(Recording Timer setting)

Clock setting

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs The clock loses the setting and is reset to �0:00.� You need to set the clock again.

� 10 �