Setting the Clock and Date
1 2 3 4 5 6
Set the alarm setting dial to ALARM MODE OFF. Plug in the clock radio.
The display will flash �AM 12:00�.
Correct Handle the disc by its edge.
To Set the Wake Up Track
1
The display shows the frequency for a few seconds and then changes back to the current time. For the radio alarm, preset the station to be used as the alarm onto preset button 1. Do not touch the surface.
Press WAKE UP TRACK for a few seconds until you hear a beep.
The track number flashes on the display.
2 3
Press TUNING + or � to select the desired track number.
The track number can be set up to 99.
Incorrect
Press CLOCK for a few seconds.
You will hear a beep and the year will start to flash in the display.
To change a preset station
Tune in manually to the station you want to store and hold down the preset button until you hear two short beeps. The previously stored station will be replaced by the new one.
Press WAKE UP TRACK again.
Two short beeps sound to confirm the setting.
Press CLOCK + or � until the correct year appears in the display. Press CLOCK once. Repeat steps 4 and 5 to set the month, day, hour, and minute.
After setting the minute, press CLOCK to start the counting of the seconds, and you will hear two short beeps. Do not stick paper or tape nor write anything on the surface.
Tuning in to a preset station
1 2
Press RADIO�SLEEP to turn on the radio. Press the STATION�SELECT/PRESET button where the desired station is stored. Adjust the volume using VOLUME.
After a few seconds, the display returns to the current time but the preset button number remains.
To Check the Alarm Time
Press ALARM TIME CHECK. The display shows the alarm time for a few seconds and then returns to show the current time. When the alarm setting dial is set to either ALARM MODE OFF or ALARM MODE A+B, the alarm time in ALARM MODE A and then ALARM MODE B appears in the display.
� Alarm time in ALARM MODE A and ALARM MODE B is set at AM 12:00 when you purchased the unit.
Note
If you press CD u when there is no disc in the CD compartment, �00� flashes for about 5 seconds on the display and the unit turns off automatically.
� To display the year and date, press SNOOZE/ DATE/SLEEP OFF once for the date, and within 2 seconds press it again for the year. The display shows the date or year for a few seconds and then changes back to the current time. � To set the current time rapidly, hold down CLOCK + or �. � In step 6, when you press CLOCK after the minute setting to activate the clock, the seconds start counting from zero. � When the alarm setting dial is set to ALARM TIME SET A or B, the clock cannot be set.
Various Modes of CD Playback
You can play tracks repeatedly or in random order.
3
FM wire antenna
Press CD PLAY MODE. Each press changes the play mode as follows:
Display indication Play mode
Setting the Alarm
This radio is equipped with 3 alarm modes � CD, radio and buzzer. Before setting the alarm, make sure to set the clock (see �Setting the Clock�).
ALARM ON�
When the alarm comes on at the preset time, � �, � �, or � � flashes in the display. For the buzzer alarm, the beeping of the alarm becomes more rapid after every few seconds in five progressive stages. � When CD and radio, or buzzer alarms are set for the same time, and you choose ALARM MODE A + B, the CD alarm takes precedence.
AC power cord
To Set the Alarm Time
To set the alarm:
To change the display to the daylight saving time (summer time) indication
Press D.S.T./SUMMER T. � � is displayed and the time indication changes to summer time. To deactivate the summer time function, press D.S.T./SUMMER T. again.
none
(normal play) <
All the tracks are played once. m
1
�REP 1�
(single repeat)
A single track is played repeatedly. m
Set the alarm setting dial to ALARM TIME SET A (CD). After one beep, � � and the alarm time
set in the previous time will flash in the display.
Note
If you set the CD alarm and there is no disc in the CD player, the buzzer alarm will sound in its place at the time set.
�REP ALL�
All the tracks are played repeatedly. m
(all repeat)
2
Press CLOCK + or � until the desired time appears.
When CLOCK + or � is held down, the displayed time initially changes in oneminute steps, and after a few seconds, switches to ten-minute steps.
Playing a CD
An 8 cm (3-inch) CD can be played without an adaptor.
�SHUFFLE�
(shuffle play)
All the tracks are played once in random order. m
To Doze for a Few More Minutes
Press SNOOZE/DATE/SLEEP OFF.
The CD, radio or buzzer alarm turns off but will be automatically activated again after about 8 minutes. Every time you press SNOOZE/DATE/ SLEEP OFF, the snooze time changes as follows:
1 2
Push OPEN/CLOSE to open the CD compartment lid and place a disc. Close the CD compartment lid.
Push
�SHUFFLE REP� (shuffle repeat)
All the tracks are played repeatedly in random order.
3
Set the alarm setting dial to ALARM MODE OFF. Two short beeps will confirm the setting.
To set the
or
alarm:
8
16 40
24 48
32 56 60
Playing the Radio Manual Tuning
1
Press RADIO�SLEEP to turn on the radio.
�RADIO� appears in the display. The display shows the band and frequency for a few seconds and then changes back to the current time.
1
Set the alarm setting dial to ALARM TIME SET B (radio or buzzer).
After one beep, � � or � � and the alarm time set in the previous time will flash in the display.
Alarm setting dial
Labeled surface up
The display shows the snooze time for a few seconds and returns to show the current time. When you press SNOOZE/DATE/SLEEP OFF after the current time appeared, the snooze time starts from 8 minutes again. � The maximum length of the snooze time is 60 minutes.
2
Press CLOCK + or � until the desired time appears.
When CLOCK + or � is held down, the displayed time initially changes in oneminute steps, and after a few seconds, switches to ten-minute steps.
ALARM OFF�
The alarm is turned off automatically after 60 minutes.
2
Close the lid
Press BAND repeatedly to select the desired band. Use TUNING + or � to tune in to the desired station.
The FM frequency advances or reverses in 0.1MHz channel steps and the AM frequency in 10kHz channel steps. Two short beeps sound when the minimum frequency of each band is received during tuning.
3
3
Set the alarm setting dial to ALARM MODE OFF. Two short beeps will confirm the setting.
To Stop the Alarm
Press OFF�ALARM RESET to turn off the alarm.
The alarm will come on again at the same time the next day.
3 4
To
Press CD u.
�CD N� and �01� appear on the display to indicate that track 1 of the CD is playing.
4
� When the alarm setting dial is set to ALARM TIME SET A or B, the sound of the CD or the radio will be interrupted.
To Cancel the Alarm
Set the alarm setting dial to ALARM MODE OFF.
Adjust volume using VOLUME.
Turn VOLUME to adjust the volume.
Press CD u CD u again .**
Pause Resume play after pause Locate the beginning of the current track (AMS*) Locate the next track (AMS) Go back at high speed Go forward at high speed Locate the previous track (AMS) Locate the succeeding track (AMS) Stop play
� To turn off the radio, press OFF�ALARM RESET. � To improve radio reception FM: Extend the FM wire antenna fully to increase reception sensitivity. AM: Rotate the unit horizontally for optimum reception. A ferrite bar antenna is built into the unit. Do not operate the unit over a steel desk or metal surface, as this may lead to interference of reception. � To check the station being received, press TUNING + or � lightly. The display shows the band and frequency for a few seconds and then changes back to the current time. � If the radio alarm comes on while the radio is on, the unit switches to the station on preset button 1 (WAKE UP STATION).
To Set the Alarm Mode
Before setting the alarm mode, be sure to set the alarm time. (See �To Set the Alarm Time�.) Set the alarm setting dial to the desired alarm mode (A, B, or A+B). When the alarm setting dial is set to ALARM MODE B or A+B, you can choose or by switching the modes in ALARM B. According to the alarm mode that you set, , , or will appear in the display. Alarm CD Radio Buzzer Set the alarm setting dial to ALARM MODE A ALARM MODE B ALARM MODE B Set Display ALARM B to ������ RADIO BUZZER RADIO BUZZER
Setting the Sleep Timer
You can enjoy falling asleep to the radio using the built-in sleep timer that turns off the radio automatically after a preset duration.
>** Hold down .** Hold down >** . repeatedly** > repeatedly** OFF�ALARM RESET
Press RADIO�SLEEP.
The radio turns on. You can set the sleep timer to durations of 90, 60, 30, or 15 minutes. Every push changes the display as follows:
On 15
90 30
60
Two short beeps sound when the display returns to �On�. �SLEEP� will appear in the display when the duration time is set. The radio will play for the time you set, then shut off. � To turn off the radio before the preset time, press SNOOZE/DATE/SLEEP OFF.
Preset Tuning
You can preset up to 5 stations; one station for each preset buttons 1 to 5, for one-touch tuning.
* AMS = Automatic Music Sensor **These operations are possible during both play and pause.
Presetting a station
Example: To preset AM 1260 kHz onto preset button 2.
CD and ALARM MODE Radio A+B
1 2 3
Press RADIO�SLEEP to turn on the radio. Tune in to the station on AM 1260 kHz (See �Manual Tuning�). Hold down the desired STATION�SELECT/PRESET button (in this case, 2) until you hear two short beeps.
CD and ALARM MODE Buzzer A+B
To Use Both the Sleep Timer and the Alarm
You can enjoy falling asleep to the radio and be awakened by the CD, radio or buzzer alarm.
When the radio alarm is activated, the radio station that is preset on the preset button 1 (WAKE UP STATION) turns on at the preset time. For the radio alarm, make sure you have preset a radio station onto preset button 1 (See �Preset Tuning�).
1 2
Set the alarm. (See �Setting the Alarm�.) Set the sleep timer. (See �Setting the Sleep Timer�.)
