Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
Installation
Unpacking
All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. Using a spanner, unscrew and remove the two rear bottom screws. Slide out the two plastic pins. Lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor. 6. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet.
P1128
P0002
Positioning
Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
P1129
P0001
2. Remove the polystyrene block from the bottom of the machine and release the two plastic bags.
1 2 3
P1051
P1124
Water inlet
3. Very carefully slide out the left polythene bag, removing it towards the right and then downwards. 4. Very carefully slide out the right polythene bag, removing it towards the left and then upwards. Connect the water inlet hose to a tap with a 3/4" thread. Do not use already employed hoses. The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
P1126
P1127
5. Set the machine upright and remove the remaining rear screw. Slide out the relevant pin.
P1088
P0021
The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. 31
