LOEWE Individual 40 Selection
Instrukcja Obsługi

First installation
Directing DVB-T antenna
Note: not with DVB-T stations in GB. If you use a room antenna to receive one or more DVB-T stations that have picture and sound interference, then you should change the location of where the antenna is set up. To help you direct your antenna or to help you determine the most suitable location to set up the antenna, your TV set has a display for the signal quality C/N and the signal strength Level. Consult your specialist dealer to �nd out which channels and frequency bands (VHF or UHF) are used to broadcast the digital TV stations in your area. On any one channel, several digital stations are broadcast.

Daily operation
Switching on/off
Your TV is equipped with an eco-standby power supply unit. On standby, the power consumption drops to low power. If you want to save even more electricity, switch the set off with the mains switch. However, please bear in mind that EPG data (electronic programme guide) will be lost and programmed timer recordings will not be performed by the TV. Switching off If the TV set is switched on, you can switch it to standby using the blue ON/OFF button on the remote control or by using the indicator �eld on the set. The red lamp on the TV set lights up. If the orange indicator lights up, a timer recording is being made, EPG data is being captured or radio operation without screen display is active. Switching on the TV set From standby, it is best to switch the set back on using the blue On/Off button or by using the numeric buttons of the remote control (0 � 99). Or use the switch integrated in the indicator on the set. The green indicator on the TV set lights up. Or switch on the TV set with OK, you can then see the station list and select a station. Switch on the radio With the RADIO button on the remote control or: Switch on radio using R on the control ring of the TV set.

Select a TV channel
1. Call the �TV menu� via the MENU button. 2. Use to select �Settings�, then use to select the menu line underneath. 3. Select �Stations�, then use to select the menu line underneath.
TV menu Settings Stations Manual adjustment Parental lock ... Timer functions
INFO END

Language

4. Select �Manual adjustment� and call the menu using OK (not possible for MHEG-5 device versions).
Manual adjustment Signal source Channel Frequency Name Bandwidth C/N 96 DVB-T E 05 177.50 MHz Test 7 MHz Level 99
END

DVB-C Antenna/cable (analogue)

OK

5. For digital stations, select �Signal source � DVB-T�. 6. Use the numerical buttons to specify the corresponding channel number. Depending on the channel selected and country, the system automatically sets the corresponding bandwidth of 7 or 8 MHz. You should only change the bandwidth under special circumstances - if the channel raster in your area is different from the standard. When you receive a digital station, the system displays the signal quality C/N via a bar/numeric value and the signal strength via Level. The antenna�s direction or position is best when the largest values possible are displayed (long bar) for the signal quality and signal strength. 7. Direct the antenna so that the largest numerical value/bar size is reached. 8. If no signal is found in the channel set, you can start the frequency search run by pressing the blue button within the band selected (VHF or UHF). 9. Check the other channels one after another on which digital stations are broadcast terrestrially in your area. For the weakest station, direct the antenna so that the maximum numerical value/bar size is achieved. 10. After you position or direct the antenna, we recommend to search for all the stations using the �Search wizard� (TV menu � Settings � Stations � Search wizard).

RADIO

If you switch off the TV set using the mains switch on the set, the indicator no longer lights up. If the TV set is switched off via the mains switch, you have to switch it into the standby mode �rst via the mains switch and then switch it on using one of the above mentioned methods.

13 -