JBL JSR625
Instrukcja Obsługi

FRONT PANEL CONTROLS

12

MEMORY TUNE / PRESET BUTTON

14

SEEK / STEREO BUTTON

Press the TUNE/PRESET side of this button to light up the preset mode then use the up/down buttons momentarily to scan the preset station frequencies. The receiver stops at each preset location from 1�30 that has been entered in memory. Hold the button down to skip through the presets quickly. In the TUNE mode press these buttons to change selected frequencies.
13

Press this button, �Auto� will illuminate in the display. Then press the TUNE/PRESET button. The tuner will automatically seek out stations in your area that have enough signal strength to be listenable. The tuner will stop on stations until the SEEK/STEREO button is pressed again.
15

VOLUME CONTROL

MEMORY BUTTON

Turn the VOLUME clockwise to increase the volume and counterclockwise to decrease it. The volume of the front, center, and rear channels is changed at the same time.
16

Use this button to store an AM or FM frequency. Press this button and select one of 30 preset locations to store the frequency with the TUNE/PRESET buttons while the MEMORY indicator blinks, press MEMORY again to store preset station. NOTE: When you store a frequency in a memory location that already contains a frequency, you replace the previous frequency. If your receiver is disconnected from AC power for more than about 2 weeks, it loses all stored frequencies.

DISPLAY WINDOW

This window shows the state of operation for easier control of the receiver. It also contains the IR Remote Sensor.

5