Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 17 (kliknij aby zobaczyć)
Getting Ready to Play
5
fig.1-03d.e
Use the tool supplied with the Wave Expansion Board to rotate the board holders to LOCK, securing the Wave Expansion Board in place.
LOCK
6
Use the (specified) screws you removed in step 2 to reattach the cover.
This completes the installation of the Wave Expansion Board. Next, make sure the board is installed correctly.
1 2
fig.1-04
Switch on the power to the JV-1010 (p. 20). Press the VALUE knob to choose the Patch mode (PATCH).
When a Wave Expansion Board is installed, then when you switch on the power first roland Jv-1010 is displayed, and after that the final two digits of the model number for the installed Wave Expansion Board flash twice on the display. For example, when the SRJV80-02 �Orchestral� Wave Expansion Board is installed, 02 flashes twice on the display.
Pressing the VALUE knob makes the mode change sequentially. Press the knob several times, until the PATCH indicator lights up.
3
fig.1-05
Turn the CATEGORY/BANK knob to choose WAVE-EXP.
If the display shows - - -, it�s likely that the Wave Expansion Board is not being recognized correctly. Follow the steps in �Switching Off the Power� (p. 20) to switch off the power, then reinstall the Wave Expansion Board, making sure you do it correctly.
If 001 appears in the display, the Wave Expansion Board has been installed correctly.
