|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Setting the Roller Cleaner
1 Open the top cover while keeping the front cover open.
NOTE: Press both sides until the top cover clicks.
4 Remove the charger cleaner from the rear cover.
2 Remove the roller cleaner from the plastic bag and set it on the
fusing unit.
5 Insert the charger cleaner into the main charger and clean the
metal plate by sliding the cleaner as shown below.
3. Close the top cover until it clicks. 4. Close the front cover until it clicks. NOTE: � Do not pull out the cleaner halfway on the metal plate. Be sure to end at either the left or the right end on the plate.
4. Cleaning
(1) Cleaning the Main Charger
1 Turn off the power. 2 Open the front cover.
6 Replace the charger cleaner on the rear cover. 7 Close the photoconductor cartridge until it clicks. 8 Close the front cover. 9 Turn on the power.
�
Push the cover release lever ( 1 ) and open the cover by holding both sides ( 2 ).
2
(2) To clean the transfer charger:
1. Turn off the power. 2. Open the front cover.
1
�
Push the cover release lever ( 1 ) and open the cover by holding both sides ( 2 ).
2
3 Position the photoconductor cartridge vertically.
1
�
Insert your hand into the opening between the face down tray and the photoconductor cartridge. Push the lever at the back of the photoconductor cartridge with your fingers and then rotate the cartridge until the cartridge is positioned vertically. The main charger exists near the drum. 3. Remove the charger cleaner from the rear cover.
Main Charger
� 10 �
|
|
|
> |
|
