JVC KA-C76
Instrukcja Obsługi

Attaching the Rubber Packing
(if it is not already attached to the camera main unit)

� If rubber packing is not attached, it is necessary to first correctly attach the rubber packing before attaching the main unit cover. In this case, attach by following the procedure described below.

Dome Cover

Rubber Packing

Dome Cover (KA-C76)

Rubber Packing

Rubber Packing

Tab
Cross-section

Groove
Pipe

Dome Cover Rubber Packing Pipe

1. Attach the rubber
packing in the position shown in the illustration. Make sure that the rubber packing is parallel to the pipe.

2. Align the tab on the
dome cover with the groove on the pipe and fit the dome cover.

3. Move the rubber packing upward
as shown in the cross-section diagram. When performing this, do not remove the installed dome cover from the pipe. If the dome cover is removed, the rubber packing will drop inside the pipe and it will not be possible to re-attach the dome cover. If the rubber packing is not correctly attached, the dust- and drip-proof performance of the dome cover cannot be guaranteed.

VICTOR COMPANY OF JAPAN, LIMITED

is a registered Trademark owned by VICTOR COMPANY OF JAPAN, LTD. is a registered Trademark in JAPAN, the U.S.A., the U.K. and many other countries. © 2002 VICTOR COMPANY OF JAPAN, LIMITED Printed in Japan LWT0089-001A