Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 3 (kliknij aby zobaczyć)
WIRE CODES
WOOFER INSTALLATION
TWEETER INSTALLATION
Figure 6
3
Tweeter level +3dB Tweeter level 0dB
�
Figure 3 Figure 4
1
ROTATE TO AIM ANGLED TWEETER TO LISTENER
+
1
SLIDE UP OR DOWN TO ADJUST TWEETER ANGLE
2
KX00
+0db +3dB
TIGHTEN NUT AND WASHER TO LOCK THE ANGLE SETTINGS
+ IN +W+T-
2
Fasten the midrange through the plastic grille tray with the screws and clips provided. Press the metal mesh in place in the tray.
Mounting the tweeter using the I-Mount surface-mounting kit.
To amplifier speaker output
To woofer
To tweeter
Aim the tweeter at the listening position by sliding the stud in the groove on the back of the tweeter cup and rotating the entire assembly in the mounting surface. Lock the tweeter in place using the small retaining nut and the large plastic mounting nut.
Figure 2 Connect the speakers and amplifier to the crossover as shown.
Figure 5
1 2
Mounting the tweeter using the I-Mount flush-mounting kit.
