Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 3 (kliknij aby zobaczyć)
INSTALLATION
Figure 3. Mounting the 60.3cs woofer in a standard speaker location. A variety of adapter rings are supplied to fit many installation configurations. Figure 5A. Mounting the tweeter using the I-Mount� flush-mounting kit. Figure 6. Mounting the tweeter using the I-Mount� surface-mounting kit. blk blk red
1 2
CONNECTIONS
Remove the cover and mount the crossover network. Observing proper polarity, connect the speakers and amplifier, as shown in Figures 7A and 7B. When done, replace the cover. Figure 7A. Wiring connections on the crossover network (shown with cover on).
� +
1 2
red
� +
2ohm
p/s 050
5.4uF
6.8uF 0.22mH
2ohm
Figure 5B. Aiming the tweeter at a desired listening position. 3
ROTATE TO AIM ANGLED TWEETER TOWARD LISTENER. ADAPTER RING(S) To AMPLIFIER SPEAKER OUTPUTS
- IN +
- WF +
- TW + -3dB
0.15mH
To WOOFER
Blk
Red To TWEETER
1 Figure 4. Mounting the 65.3cs in a 165mm speaker location.
SLIDE SCREW UP OR DOWN TO ADJUST TWEETER ANGLE.
Figure 7B. Locating wiring connections on the 50.3cs woofer. Other woofers are wired similarly.
