WHIRLPOOL KCIP 1010
Instrukcja Obsługi

Installation
Fig. 6 � Attach the chimney flue support bracket G to the wall next to the ceiling, using the chimney support bracket as a template (the small slot created on the bracket must coincide with the line previously traced on the wall) mark the 2 holes with a pencil, drill the holes and insert the 2 plugs. � Fit the chimney support bracket to the wall with the 2 screws. Only Vented mode version: fit the deflector to the chimney support bracket using 4 screws. Fig. 7 � Hook the hood onto the lower bracket. � Fit the hood securely to the wall with screws and washers � Connect the venting pipe (vent pipe and straps for fitting are not provided and must be purchased separately) for the exhaust fumes to the connection ring found above the motor suction unit. The other end of the pipe should be attached to the extractor hood. If you wish to use the extraction hood in the recirculation mode, then connect the other end of the pipe to the connection ring on the deflector F. � Connect the electrics. � Attach the chimneys and fit them above using 2 screws to the chimney support bracket, G. � Lower the lower part of the fully covered chimney suction unit slide down until it fits into the specific slot in the hood and attach it to the hood using 2 screws.

chimney support bracket chimney support bracket

centre line lower support bracket

bottom fastener locations

upper duct cover

Recirculation mode only

9