JVC KDAR7500
Instrukcja Serwisowa

3.2

CD mechanism assembly section

� Remove the CD mechanism assembly from the main body. (See "3.1.5 Removing the CD mechanism assembly".) 3.2.1 Removing the mechanism control board (See Fig.1) (1) From the bottom side of the CD mechanism assembly, solder the short sections on the flexible wire. Caution: Solder the short sections on the flexible wire before disconnecting the flexible wire from the connector CN601 on the mechanism control board. If you do not follow this instruction, the CD pickup may be damaged. (2) Disconnect the flexible wire from the connector CN601 on the mechanism control board. (3) Disconnect the flexible wire from the connector CN602 on the mechanism control board. (4) Remove the solders from the soldered sections a on the mechanism control board and remove the wires of the feed motor. (5) Remove the solders from the soldered sections b on the mechanism control board, and remove each wire of the spindle motor and other parts. (6) Remove the five screws A attaching the mechanism control board. Caution: When reassembling, remove the solders from the short sections after connecting the flexible wire to the connector CN601 on the mechanism control board.

Short sections Flexible wire

CD mechanism assembly

A

Feed motor

a

CN601

A

A

A
Spindle motor

b

A

CN602

Mechanism control board Fig.1

(No.MA162)1-11