KENWOOD KDC5020
Instrukcja Serwisowa

KDC-319/4019,5020
TEST MODE
3. When the message "Security" is displayed, press and hold the Track Up/Down key for 1 second to enter the security registration mode. 4. Enter the code using the FM/AM/Track Up/Track Down keys. � FM key : Number up � Am key : Number down � Track Up key : Cursor right shift � Track Down key : Cursor left shift 5. Hold down the Track Up key for at least 3 seconds and the message, "RE-ENTER" appears, so once again enter the code according to Step 4 above. 6. Press and hold the Track Up key for 3 seconds until "APPROVED" is displayed. 7. Exit from the test mode. (See 2. How to exit from the test mode) (Note) All Clear is not applicable to the security code of this model. 3. Simplified method of clearing the security code (K Type only) 1. While the code entry is requested, press and hold the VOL UP key for 3 seconds while holding the DISP key pressed. (This should turn "----" off.) 2. Enter "KCAR" from the remote. (Same way as the 01 model) � Press the 5 key on the remote twice, then press the Track Up key. (This enters "K".) � Press the 2 key on the remote 3 times, then press the Track Up key. (This enters "C".) � Press the 2 key on the remote once, then press the Track Up key. (This enters "A".) � Press the 7 key on the remote twice, then press the Track Up key. (This enters "R".) 3. The security code is cleared and the unit enters the ALL OFF mode. 4. If you commit a mistake in the code entry, the unit enters the code request mode again.

8