Adjusting the sound
ENGLISH
You can adjust the sound characteristics to your preference.
*1 When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the currently selected sound mode (C-EQ) including �USER.� *2 If you are using a two-speaker system, set the fader
1
Select the item you want to adjust.
Each time you press the button, the adjustable items change as follows:
*3 Normally the control dial works as the volume
level to �00.� control. So you do not have to select �VOL� to adjust the volume level. *4 Depending on the amplifier gain control setting. (See page 24 for details.)
BAS
(bass)
TRE
(treble)
FAD
(fader)
2
Adjust the setting.
To increase the level or turn on the loudness To decrease the level or turn off the loudness Indication pattern changes as you adjust the bass or treble.
VOL
(volume)
LOUD
(loudness)
BAL
(balance)
Indication BAS*1
To do: Adjust the bass.
Range �06 (min.) | +06 (max.)
TRE*1
Adjust the treble.
�06 (min.) | +06 (max.) R06 (Rear only) | F06 (Front only) L06 (Left only) | R06 (Right only) Ex. 2: When you turn on the loudness
FAD*2
Adjust the front and rear speaker balance. Adjust the left and right speaker balance. Boost low and high
Ex. 1: When you adjust �TRE� (treble)
BAL
LOUD*1
VOL*3
frequencies to LOUD ON produce a well| balanced sound LOUD OFF at low volume level. Adjust the volume. 00 (min.) | 30 or 50 (max.)*4
3
Repeat steps 1 and 2 to adjust the other items.
To reset each sound mode to the factory settings, repeat the same procedure and reassign the preset values listed in the table on page 21.
