jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 26 (kliknij aby zobaczyć)
KD-SC945
3.2.1 Feed section
Is the voltage output at IC541 pin "40" 5V or 0V? YES Is 4V present at both sides of the feed motor? YES Check the feed motor.
NO
Is the wiring for IC501 pin 27? NO
YES Is 3.3V present at IC501 pin "20"? YES Check the vicinity of IC541. YES Check the feed motor connection wiring.
NO Check CD 8V and 5V.
NO
Is 6V or 2V present at IC501 "4" and "5"? NO Check IC501.
3.2.2 Focus section
When the lens is moving: 4V
Does the S-search waveform appear at IC501 pins "8" and "9"?
NO
Check the circuits in the vicinity of IC501 pins "8","9"and"15". YES
YES
Check the pickup and its connections
3.2.3 Spindle section
Is the disk rotated? YES Does the RF signal appear at RF test point? YES Is the RF waveform at RF test point distorted? YES Proceed to the Tracking section
NO
Is 4V present at IC501 pins "6" and "7"? YES
NO
Is 4V present at IC541 pins "41" ? YES Check the vicinity of IC501.
NO
Check the spindle motor and its wiring NO NO Check the circuits in the vicinity of IC501 "19"~ "24" or the pickup
Check IC541 and IC501.
3.2.4 Tracking section
When the disc is rotated at first:
YES
Approx. 1.2V Is the tracking error signal output at IC501 "11"?
Check the circuit in the vicinity of IC501 pins "2"~"12".
