|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
SOUND ADJUSTMENTS
Performing the basic sound settings
You can set the speaker output balance, subwoofer output level, and input level of each source. � There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.
2
Adjust the level.
To adjust fader and balance�Fad, Bal: Make these two adjustments at the same time. � If you are using a two-speaker system, set the fader level to �00.� � Press 5 (up) or � (down) to adjust the fader. � Press ¢ or 4 to adjust the balance.
1
Press SEL (select) repeatedly to show one of the basic sound setting (SEL) screens.
SEL
Each time you press the button, the adjustable items change as follows:
DSP
iEQ
Basic sound settings
Fad/Bal
To adjust subwoofer output�Sub Out: This takes effect only when a subwoofer is connected.
ATT
Canceled
Vol Adj
BBE
Sub Out
To increase the level. To decrease the level.
� For DSP mode settings, see pages 32 to 34. � For iEQ (sound mode) settings, see pages 35 and 36. Indication Fad To do: Range
Adjust the front R06 (Rear only) and rear speaker | balance. F06 (Front only) Adjust the left L06 (Left only) and right speaker | balance. R06 (Right only) Adjust the subwoofer output level and cutoff frequency level. Make sounds natural. Adjust and store the input level of each source. 00 (min.)
|
You can also set an appropriate cutoff frequency level according to the subwoofer connected. � Press ¢ or �Mid,� or �High.� Low: 4 to select �Low,�
Bal
Sub Out
08 (max.) Low/Mid/High BBE Off, BBE 1, BBE 2, BBE 3 �05 (min.)
|
BBE Vol Adj
Frequencies higher than 50 Hz are cut off to the subwoofer. Mid: Frequencies higher than 80 Hz are cut off to the subwoofer. High: Frequencies higher than 115 Hz are cut off to the subwoofer.
+05 (max.)
37
ENGLISH
|
|
|
> |
|
