Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 17 (kliknij aby zobaczyć)
Initial Settings
Adjusting initial settings
Setting the time
English Español Deutsch Français Italiano Nederlands
This is used to set the time on the unit�s clock display. 1 Press AUDIO to select the time. Press AUDIO until the time appears in the display.
Initial settings lets you perform initial set up of different settings for this unit. 1 Press SOURCE and hold until the unit turns off. 2 Press AUDIO and hold until TIME appears in the display. Press AUDIO repeatedly to switch between the following settings:
TIME�FM STEP�AM STEP�AUX
2 Select the portion of the time display you wish to set with 2/3. Pressing 2/3 will select a portion of the clock display:
HOUR�MINUTE
As you select portions of the clock display the portion selected will blink.
Use the following instructions to operate each particular setting. � To cancel initial settings, press BAND. � You can also cancel initial settings by holding down AUDIO until the unit turns off.
3 Select the correct time with 5/�. Pressing 5 will increase the selected hour or minute. Pressing � will decrease the selected hour or minute.
Setting the FM tuning step
The tuning step employed by Seek Tuning in the FM mode can be switched between 100 kHz (preset at the factory) and 50 kHz. 1 Press AUDIO to select FM STEP. Press AUDIO repeatedly until FM 100 appears in the display. 2 Select the FM tuning step with 2/3.
