Equalizer curve fine adjustment
You can adjust the center frequency and the Q factor (curve characteristics) of each currently selected curve band (EQ-LOW/EQ-MID/EQHIGH).
Adjusting bass
English Español Deutsch Français Italiano Nederlands
You can adjust the cut-off frequency and the bass level. In FRT1 mode, bass adjustment affects only the rear output: front output cannot be adjusted. 1 Press AUDIO to select BASS. Press AUDIO until BASS appears in the display.
Level (dB)
Q=2N Q=2W Center frequency Frequency (Hz)
2 Select the desired frequency with 2/3. Press 2 or 3 until the desired frequency appears in the display. 40�63�100�160 (Hz) 3 Press 5 or � to adjust the bass level. Each press of 5 or � increases or decreases the bass level. +6 � �6 displayed as the level is increased or decreased.
1 Press AUDIO and hold until frequency and the Q factor (e.g., F-80 Q-1W) appears in the display. 2 Press AUDIO to select the desired band for adjustment. Press AUDIO repeatedly to switch between the following bands: EQ-LOW (low)�EQ-MID (mid)�EQ-HIGH (high) 3 Press 2/3 to select the desired frequency. Press 2 or 3 until the desired frequency appears in the display. LOW: 40�80�100�160 (Hz) MID: 200�500�1K�2K (Hz) HIGH: 3K�8K�10K�12K (Hz) 4 Press 5/� to select the desired Q factor. Press 5 or � until the desired Q factor appears in the display.
2N�1N�1W�2W
Note � If you make adjustments when a curve other than CUSTOM2 is selected, CUSTOM1 curve is updated.
