Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
Using the cooktop
Turning on and off / Regulating
The control knob is used to turn on the burner and to regulate the strength of the flame. Regulating the burners The inner and outer burners are both controlled by one control knob. There is a stop at the 6 o�clock position that requires you to press the knob down while turning it in order to get from the high flame to the low flame zone. ^ To reduce the flames from a high to low setting, turn the control knob counterclockwise until you feel resistance. Press the knob down to pass the stop, then release the pressure and set the cooktop to the desired setting. ^ To increase the flames from a low to high setting, turn the control knob clockwise until you feel resistance. Press the knob down to pass the stop, then release the pressure and set the cooktop to the desired setting.
Turning on ^ To turn on the burner, press the control knob down and turn it counterclockwise to the largest flame symbol. The ignitor will click and ignite the gas. ^ When the flame appears, keep the control knob pressed in for 8-10 seconds to allow the Ignition Safety Control to reach operating temperature. Release the knob. If the flame goes out, repeat the above procedure, keeping the control knob pressed in for a few extra seconds. ^ Release the knob and adjust it to the desired setting.
