|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Chapter Two : Setting Up the Remote Control Unit
Setting Up Speakers
Before you can begin using the receiver to control your home entertainment system, you must set up Remote Control unit to operate your speakers effectively. There are three areas of speaker setup: � � � SP Selection SP Level SP Distance 2. Press the Setup key (LCD function key 2). 5. When the front (left and right) speaker setting menu (Front) appears, select Front Normal or Large in the same way as step 4, then press the Next key. (If you set the subwoofer to Off in step 4, skip this step.) 6. When the center speaker setting menu (Center) appears, select Center Normal, Large or Off in the same way as step 4, then press the Next key. Select Off when no center speaker is connected. (If you select Normal in step 5. �Large� cannot be selected here.) 7. When the surround (left and right) speaker setting menu (Surround) appears, select Surround Normal, Large or Off in the same way as step 4, then press the Next key. Select Off when no surround speaker is connected. (If you select Normal in step 5. �Large� cannot be selected here) � Select Normal if the speaker is not capable of producing clean, deep bass energy at output levels that match those produced by a typical powered subwoofer. All bass below 80Hz in that channel is removed from that speaker and is sent to the subwoofer in all listening modes. Most speakers should be considered Normal. If no subwoofer is connected, that signal is sent to left and right front speakers. � Select Large if the speaker is capable of producing clean, deep bass energy at output levels that match those produced by a typical powered subwoofer. All bass below 80Hz in that channel is left in that speaker in all listening modes. The subwoofer may not output audio depending on the input signal, speaker setup and listen mode.
01.IR 02.Surround 03.Contrast Home Enter
The receiver must be on and speakers must be connected before you can set up speakers.
Speaker Selection:
Remote Setup
Press the Music key or Movie key to display the �Menu�.
Tuner FM 01ch Auto 87.50MHz Menu
3. Press the LCD cursor up/down key ( , ) to select �02. Surround�, then press the Enter key (LCD function key 2)
36
Surround SetUp Sub Woofer = On Home
1. Press the Menu key (LCD function key 2).
Next
Home
Setup
4. Press the LCD cursor up/down key ( , ) to select Sub Woofer On or Off, then press the Next key (LCD function key 2). � If you selected On for the subwoofer, all of the bass below 80Hz is removed from all other Normal setting speakers in your system and is sent to the subwoofer in all listening modes. This improves your speakers� power handling and reduces overall distortion. � If you selected Off for the subwoofer, the bass tone is output from the front L and R speakers.
|
|
|
> |
|
