Adjusting the sound
SOURCE DIRECT VOLUME CONTROL SOUND
Muting the sound
The MUTE key lets you mute the sound of the speakers. Press the MUTE key.
SP A B TI.VOL CLIP MUTE RDS EON PTY TP TA NEWS
17
L
LFE
C S
R
SW
LS
RS
Blinks
To cancel
PHONES MULTI CONTROL SPEAKERS A/B
Press the MUTE key again so that the �MUTE� indicator goes off. � Muting can also be canceled by adjusting the volume.
SOURCE DIRECT playback (analog sources only)
5/� MUTE F.SHIFT VOLUME +/� SOUND BASS BOOST
Use this function to pass the source material direct to the amplifier, bypassing any audio processing. Press the SOURCE DIRECT key.
FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S.DIRECT MEMO MHz 3 STEREO MONITOR ST. kHz DOWN MIX DSP TUNED
Adjusting the tone
You can adjust the sound quality when the receiver is in the stereo mode. 1 Press the SOUND key to select the tone mode to be adjusted. BASS: Select this to adjust the low frequency range. (Press the SOUND key once.) TREB: Select this to adjust the high frequency range. (Press the SOUND key twice.)
SP A B TI.VOL CLIP MUTE RDS EON PTY TP TA NEWS
� When you press the LISTEN MODE, SOUND, or SETUP keys, or switch to another input source, SOURCE DIRECT playback will be canceled.
To cancel
Press the SOURCE DIRECT key again. � If SOURCE DIRECT playback was activated when using a surround mode, cancelling it reactivates the previous surround mode.
L
LFE
C S
R
SW
LS
RS
FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S.DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP
Listening with headphones
1 Press the SPEAKERS A or B key so that the speaker indicator goes off. Make sure the Speaker indicator are turned off.
SP A B TI.VOL CLIP MUTE RDS EON PTY TP TA NEWS
2 Use the MULTI CONTROL knob or the 5/� keys to adjust the sound quality. � The bass and treble levels are adjustable from -10 to +10 in 2 step increments. � The adjustment item is displayed for approximately 8 seconds.
L
LFE
C S
R
SW
LS
RS
Once-touch low frequency emphasis (bass boost)
You can adjust the sound quality when the receiver is in the stereo mode. Press the F.SHIFT key, then press BASS BOOST key. � Press the key once to select the maximum (+10) low frequency emphasis setting. � This key does not function when the receiver is in the sound quality or ambience effects adjustment mode. � If you turn off all of the speakers when in the surround mode, the mode is cancelled as well, resulting in stereo playback. � The speakers do not switch off during the 6CH INPUT mode. Select the other input mode. 2 Connect headphones to the PHONES jack.
PHONES
Switching back to the previous setting
Press the BASS BOOST key again.
3 Use the VOLUME CONTROL (VOLUME+/-) to adjust the volume.
