KENWOOD KSC32
Instrukcja Serwisowa

KSC-32
FLOW CHART
About voltage write down, Li-ion & Ni-MH is S terminal voltage. Ni-Cd is not equal B+1 voltage. Ni-Cd = (B+1 voltage) � Vf Therefore Ni-Cd voltage must consider Vf of protected reverse connection diode.
START Does T,S contact? No

Yes Power out (57mA, 4S) to return protection circuit inside Li-ion Distinguish battery Li-ion

Distinguish battery Ni-Cd or Ni-MH T < 0°C or T > 40°C Temperature check 0°C < T < 40°C 0°C < T < 40°C Below6.6V Above 6.6V

Ni-Cd or Ni-MH

Stand-by temperature LED : Red

Above 11.3V

Above 8.55V or Below 0.5V

Stand-by temperature LED : Red

T < 0°C or T > 40°C Temperature check 0°C < T < 40°C

0°C < T < 40°C Below 5.5V Passage 90min. or Below 0.5V Above 5.5V Low voltage battey charge : 170mA 90 min. timer start LED : Red Error battery timer stop LED : Red flash Go to START when T contact is off. Above 5.5V 90 min. timer stop Rapid charger 1350mA Above 8.55V or Below 5.5V 180 min. timer start LED : Red Charge current is 100mA±20mA or passage 180 min. Detected full charge Finish charge timer stop LED : Green

Low voltage battey charge : 57mA Above 6.6V 20 min. timer stop Rapid charger 1350mA Ni-Cd 1000mA Ni-MH Voltage range of ��V detected 7.8~10.8V 90 min. timer start Ni-Cd 180 min. timer start Ni-MH LED : Red Detected ��V or Above 10.5V (Ni-Cd) or Above 10.8V (Ni-MH) or Passage 90 min. (Ni-Cd) or Passage 180 min. (Ni-MH) Detected full chatge 90 min. timer stop (Ni-Cd) 180 min. timer stop (Ni-MH) LED Green Ni-Cd Ni-MH 20 min. timer start LED : Red

Passage 20 min.

Below 6.6V

Below 7.8V when Rapid charge start passage 10 min.

Above 8.55V or Below 5.5V

Above 11.3V or Trickle charge : 57mA Below 6.6V 10 hour timer start LED : Green 10 hour passage Trickle charge : Ave. 5mA pulse 10 hour timer start LED : Green Finish charge 10 hour timer stop LED : Green 10 hour passage Above 11.3V or Below 6.6V

Above 11.3V or Below 6.6V

5