Setting Attenuation The attenuation switch on the back of the KSM32 reduces the signal level from the cartridge by 15 dB without altering the frequency response. This can prevent extremely high SPL from overloading the microphone. To activate attenuation, move the switch to the ��15 dB� position. In situations where the high output capability of the KSM32 might overload the microphone preamplifier of a console or mixer, use an attenuation switch (pad) in the mixer or an external inline attenuator such as the Shure A15AS. Load Impedance A load impedance of at least 1000 � is recommended. When used with typical modern microphone preamplifiers (rated at about 2500 �), the KSM32 provides higher maximum SPL capability and output clipping level. The KSM32 can handle up to 160 dB SPL, and output +15 dBV into a 5500 � or greater load with microphone attenuation.
SPECIFICATIONS
Cartridge Type Permanently-biasedcondenser Frequency Response 20 Hz to 20 kHz (see Figure 1) Directional Pattern Cardioid (see Figure 2) Sensitivity (at 1000 Hz) Open Circuit Voltage . . . . . . . . . . . . . . . . . . . . . . . . . �36 dBV/Pa (16 mV) typical (1 Pa = 94 dB SPL) Self Noise (equivalent SPL) 13 dB typical, A-weighted (IEC 651) Total Harmonic Distortion (20 Hz to 20 kHz , 2500 � load) < 0.08%* for a 120 dB equivalent SPL input Maximum SPL (20 Hz to 20 kHz, THD < 1%*) 2500 � Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 139 dB (154 dB w/ attenuation) 1000 � Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 133 dB (148 dB w/ attenuation) Output Clipping Level (20 Hz to 20 kHz, THD < 1%*) 2500 � Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +9 dBV (2.82 V rms) 1000 � Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +3 dBV (1.41 V rms) Dynamic Range (20 Hz to 20 kHz, 2500 � load) 126 dB (maximum SPL minus A-weighted noise level) Signal-to-Noise Ratio 81 dB (IEC 651)** Output Impedance 150 � (actual) Attenuation Switch 0 or �15 dB
