SONY KV21ME40
Instrukcja Serwisowa

KV-[13M40/50/51], KV-[14MB40/40C/40A], KV-[20M40/S40/S41/V80], KV-[21SE40/40A/40C/80/80A/80C], KV-[21MB40C/40M/40P], KV-[21ME40/40P], KV-[21SB40/40M/40P], KV-21XT4A

2-4-3. PICTURE TUBE REMOVAL

(KV-20V80/21SE80C/21SE80/21SE80A)

WARNING

Before removing anode cap:

H.V. remains in the CRT even after the power is disconnected.
Coating earth ground strap

To avoid electrical shock, discharge CRT before attempting to remove the anode cap : Short between anode and CRT coating earth ground strap.
3 Two P tapping screws 4 X 16 4 Speaker

Coil grips

1 Two P tapping screws 4 X 16

2 Speaker

� REMOVAL OF THE ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after removing the anode.

� REMOVAL PROCEDURES

Turn up one side of the rubber cap in the direction indicated by arrow .

Use your thumb to pull the rubber cap firmly in the direction indicated by arrow .

� HOW TO HANDLE AN ANODE-CAP
Do not use sharp objects which may cause damage to the surface of the anode-cap. Do not squeeze the rubber covering too hard to avoid damaging the anode-cap. A material fitting called a shatter-hook terminal is built into the rubber. Do not force turn the foot of the rubber cover. This may cause the shatter-hook terminal to protrude and damage the rubber.

When one side of the rubber cap separates from the anode button, the anodecap can be removed by turning the rubber cap and pulling it in the direction of arrow .

� 19 �