...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
Tekstowy podgląd strony 18 (kliknij aby zobaczyć)
KV-25K1
2-5. A BOARD REMOVAL
Push the claw of the bracket in the direction of the arrow and remove.
2-6. PICTURE TUBE REMOVAL
7 Holder DGC
8 Degaussing coil 9 Spring tension
C board 10 Speaker 4 Two Screws 3
6 Chassis 11 Neck Assy
Four tapping screws (M) 13
18 �
12 Deflection
Yoke
�
REMOVAL OF ANODE-CAP
carbon paint on the CRT, after removing the anode.
* REMOVING PROCEDURES.
Note: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or
2 Speaker
Anode cap 5
c
a
b b
1
Turn up one side of the rubber cap in the direction indicated by the arrow a
2
Using a thumb pull up the rubber cap 3 firmly in the direction indicated by the arrow b
�
1 2
3
HOW TO HANDLE AN ANODE-CAP Don't damage the surface of anode-cap with sharp shaped material ! Don't press the rubber hardly not to hurt inside of anode-caps ! A metal fitting called as shatter-hook terminal is built into the rubber. Don�t turn the foot of rubber over hardly ! The shatter-hook terminal will stick out or damage the rubber.
When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c
