|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Connecting Audio Equipment to the TV
Conect your audio equipment to the audio output sockets D if you wish to amplify the audio output from TV. Next, using the menu system, select the �Sound Adjustment� menu and set the �TV Speakers� to �One time off� or "Permanent off" (see page 13). The volume of the external speakers can be altered by pressing the volume buttons on the remote control. The Treble and Bass settings can also be altered through the �Sound Adjustment� menu (see page 12).
Hi-Fi speakers
To enjoy �Dolby Virtual� sound effect through your audio equipment
Place the speakers of your equipment in front of your listening position and beside the TV set, keeping a distance of 50 cm between each speaker and the TV set. Then using the menu system, select the menu �Sound Adjustment�. Next, select �Dolby Virtual� on the �Sound Effect� option (see page 12).
~50°
GB
Your sitting position
Viewing pictures from equipment connected to the TV
1 2 3
Connect your equipment to the designated TV socket, as indicated on the previous page. Switch on the connected equipment. To watch the picture of the connected equipment, press the input symbol appears on the screen.
Symbol Input Signals
button repeatedly until the correct
1 1 2 2 3
S
� Audio/video input signal through the Scart connector G � RGB input signal through the Scart connector G. This symbol appears only if an RGB source has been connected. � Audio/video input signal through the Scart connector F. � RGB input signal through the Scart connector F. This symbol appears only if an RGB source has been connected. � Audio/video input signal through the Scart connector E. � S Video Input signal through the Scart connector E. This symbol appears only if an S Video source has been connected. � Video input signal through the phono socket B and Audio input signal through C. � S Video Input signal through the front S Video input jack A and Audio signal through C. This symbol appears only if an S Video source has been connected. button on the remote control to return to the normal TV picture.
3 4
S
4
RM-945
4
Press the
For Mono Equipment Connect the phono plug to the L/G/S/I socket on the front of the TV and select 4 or S 4 input signal using the instructions above. Next, refer to the �Sound Adjustment� section of this manual and set �Dual Sound� option to �A� on the sound menu screen (see page 12).
Additional Information
23
|
|
|
> |
|
