jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 22 (kliknij aby zobaczyć)
KV-28WF1
2-7. PICTURE TUBE REMOVAL
�
REMOVAL OF ANODE-CAP
carbon paint on the CRT, after removing the anode.
Note: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or 6 Two DGC holers 7 Degaussing coil 8 Spring extension
* REMOVING PROCEDURES. c
a
b b
Anode button
1 Turn up one side of the rubber cap in the direction indicated by the arrow a
3 C board 4 Neck assy 2 Chassis assy
2 Using a thumb pull up the rubber cap 3 When one side of the rubber cap is firmly in the direction indicated by the separated from the anode button, the arrow b anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c
�
1
2 3
9 Four PT screws 5 Deflection yoke
HOW TO HANDLE AN ANODE-CAP Don't damage the surface of anode-cap with sharp shaped material ! Don't press the rubber hardly not to hurt inside of anode-caps ! A metal fitting called as shatter-hook terminal is built into the rubber. Don�t turn the foot of rubber over hardly ! The shatter-hook terminal will stick out or damage the rubber.
