Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
2-4. Service Position
2-5. G Board Removal
Clips
Position the chassis as indicated to access the solder side. To gain access to the underside of the boards follow the instructions on page 17. [Removal and Replacement of the main bracket bottom plates ].
To remove the G Board release the clips circled and ease the board gently away from the support bracket. Removal of the D board follows the same procedure.
2-6. Side Control Module Removal
2-7. H2 Board Removal
Screws
2
Clips
Remove the two screws fixing the user control module to the side of the set. The control module can then be removed by sliding it towards the rear of the set allowing access to the H2 Board.
To remove the H2 Board release the two clips circled and ease the board gently away from the support bracket.
