Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
Note about the AC Power Cord
The AC power cord is attached to the rear of the TV with hooks. Use caution when removing the AC plug from its holder. Gently slide the cord in the upward direction, without removing the cord from the two lower hooks.
You can detach the cord from this hook Do not remove the cord from these hooks.
A
� VHFonly or � VHF/UHF or � Cable
75-ohm coaxial cable
(Rear of TV) VHF/UHF
Cable and antenna
If your cable provider does not feature local channels, you may find this set up convenient.
(Rear of TV) AUX
CATV cable (No connection "TO CONVERTER" in this case) Antenna cable
B
AC Power cord
� VHFonly or � UHFonly or � VHF/UHF
300-ohm twin lead cable
(Rear of TV) VHF/UHF
TO CONVERTER
VHF/UHF Antenna connector
Select CABLE or antenna (ANT) mode by pressing ANT on the remote control.
Cable or Antenna Connections
75-ohm coaxial cable
Connecting directly to cable or an antenna
The connection you choose will depend on the cable found in your home. Newer homes will be equipped with standard coaxial cable (see A); older homes will probably have 300 -ohm twin lead cable (see B); still other homes may contain both (see C ).
C
� VHF
(Rear of TV) VHF/UHF
Note In order to receive channels with an antenna, you will need to turn your CABLE to OFF and perform the AUTO PROGRAM function, (see page 26).
and � UHF U/V mixer (not supplied) 300-ohm twin lead cable
