SONY KVG21PD1
Instrukcja Serwisowa

KV-G21PD1

RM-883

2-6. PICTURE TUBE REMOVAL
3 C board

b
4 Deflection yoke 2 A board 5 Four screws (Tapping screws)
2 Using a thumb press down then pull up the rubber cap firmly in the direction indicated by the arrow b.

b

1 Anode cap

c

12 �
Anode button
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c.

Cushion

NOTE : After removing the anode short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.

� REMOVAL OF ANODE-CAP

�

HOW TO HANDLE AN ANODE-CAP

1 Do not damage the surface of anode-caps with sharp shaped objects 2 Do not press the rubber too hard so as not to damage the inside of anode-caps A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard The shatter-hook terminal will stick out or damage the rubber.

� REMOVING PROCEDURES

a

a

1 Turn up one side of the rubber cap in the direction indicated by the arrow a.