jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
KV-G21PD1
RM-883
2-6. PICTURE TUBE REMOVAL
3 C board
b
4 Deflection yoke 2 A board 5 Four screws (Tapping screws)
2 Using a thumb press down then pull up the rubber cap firmly in the direction indicated by the arrow b.
b
1 Anode cap
c
12 �
Anode button
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c.
Cushion
NOTE : After removing the anode short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
� REMOVAL OF ANODE-CAP
�
HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects 2 Do not press the rubber too hard so as not to damage the inside of anode-caps A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard The shatter-hook terminal will stick out or damage the rubber.
� REMOVING PROCEDURES
a
a
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
