SONY KVJ51PN1
Instrukcja Serwisowa

2-7. PICTURE TUBE REMOVAL
3 C board
b

6 VM board 4 Deflection yoke 2 A board 5 Four screws (Tapping screws)

b

2 Using a thumb press down, then pull up the rubber cap firmly in the direction indicated by the arrow b.

c

1 Anode cap

� 13 �
Cushion

Anode button

3 When one side of the rubber cap is separated from the anode button, the anodecap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c.

� REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CR T shield or carbon paint on the CR T.

�

HOW TO HANDLE AN ANODE-CAP

� REMOVING PROCEDURES

1 Do not damage the surface of anode-cap with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.

KV-J51PF1S/J51PN1/J51PN21

a

a

1 Turn up one side of the rubber cap in the direction indicated by the arrow a. RM-869E