PANASONIC KXFM189PR
Instrukcja Serwisowa

backed up by a lithium battery. 3. The watch dog timer, built-in the ASIC (IC501), is initialized by the CPU about every 1.5 ms. When a watch dog error occurs, pin 137 of the ASIC (IC501) becomes low level. The terminal of the 'WDERR' signal is connected to the reset line, so the 'WDERR' signal works as the reset signal.
6.3.8. SRAM AND RTC BACKUP CIRCUIT

1. Function This unit has a lithium battery (BAT501) which works for the SRAM (IC504) and Real Time Clock IC (RTC: inside IC501). The user parameters for autodial numbers, the system setup data and others are stored in the SRAM (IC504). The RTC continues to work, backed up by a lithium battery even when the power switch is OFF. 2. SRAM (IC504) Backup Circuit Operation When the power switch is turned ON, power is supplied through pin 12 of IC501 to the SRAM (IC504). At this time, the voltage at pin 28 of the SRAM is 5V. When the power switch is turned OFF, the BAT501 supplies power to the SRAM through J501, R543 and D508. The voltage at pin 28 of the SRAM is about +2.5V. When the power switch is OFF and the voltage of +5V decreases, the voltage detect IC (IC507) outputs "Low" level and the IC501 outputs the reset signal. Pin 28 of the SRAM becomes roughly the same voltage as the battery voltage. At this point, pin 20 (CS) of IC504 becomes high level, causing the SRAM to go into the backup mode, in which the power consumption is lower. 3. RTC Inside (IC501) Backup Circuit Operation When the power switch is turned ON, power is supplied through DA501 to the RTC (inside IC501). At this time, the voltage at pin 7 of the IC501 is +3.3V. When the power switch is turned OFF, the BAT501 supplies power to RTC through DA501. Thevoltage at pin 7 of IC501 is about +2.5V. When the power switch is OFF and the voltage of +3.3V decreases, pin 7 of RTC (IC501) becomes roughly the same voltage as the battery voltage. RTC goes into the backup
182