Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 35 (kliknij aby zobaczyć)
Installation/Troubleshooting
1.13.2 Mounting on the Ceiling
Mount the camera at an even place where vibrations etc. are few. Set the Tilt range to [On the ceiling] on Camera Setup window (see page 65 of the Operating Instructions on the Setup CD-ROM). Two ways of wiring can be considered; wiring through a hole made in the ceiling or wiring without making a hole for a cable in the ceiling. Select either one of the two. Wiring through a hole made in the ceiling
1. Fix the Ceiling Plate B on the ceiling with Screws B.
� � Fix the Ceiling Plate B more than 100 mm (4 inches) off the wall or other obstacles from its center. Make sure the camera is firmly mounted on a beam of wood etc. When there is no beam, apply a board on the other side of the ceiling to make sure the camera does not drop.
Keep more than 100 mm (4 inches) off the wall or other obstacles. Camera direction
