PANASONIC KXTC1200NZW
Instrukcja Obsługi

6

Things You Should Know
6-A Battery
Recharge
When the RECHARGE indicator �ashes or the unit beeps intermittently, place the handset on the base unit for about 15 hours to recharge the battery.

�

Things

6-B Battery Replacement
If the RECHARGE indicator �ashes after being fully charged, replace the battery with a new Panasonic P-P301 (KX-A36A) battery. When replacing the battery, programmed information may be erased. Reprogram if necessary.

1
RECHARGE Indicator

Press the notch on the handset cover �rmly and slide it as indicated by the arrow.

Battery information:
After your Panasonic battery is fully charged: While in use (TALK) While not in use (Standby) Operation Up to about 5 hours Up to about 14 days Operating time

2

Replace the battery and close the cover.
�Insert the battery plug into the connector as shown in the picture. �Be sure wires are free from being pressed by the battery body or the handset cover.

�The battery operating time may vary depending on usage conditions and ambient temperature. �As preventative maintenance, clean the handset and the base unit charge contacts with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or humidity. Otherwise the battery may not charge properly. �If the battery is fully charged, you do not have to place the handset on the base unit until the RECHARGE indicator �ashes. This will maximize the battery life. �The battery cannot be overcharged. Black Lead Red Lead

3

Make sure to charge the new battery for about 15 hours.

6-C Base Unit Location
Calls are transmitted between the base unit and the handset using wireless radio waves. For maximum distance and noisefree operation, the recommended base unit location is: In a HIGH and CENTRAL

6-D Wall Mounting
This unit can be mounted on a wall.

Away from electrical appliances

1 2
Screws 8.3 cm For Australia To Telephone Plug and Socket OR

such as a TV, personal computer, cellular phone charging units or another cordless phone.

location with no obstructions such as walls.

Pull down the handset hook until it locks, so the tab holds the handset. Install screws using the wall template below. Connect the AC adaptor and telephone line cord.

3

Mount the unit, then slide down.
�Extend the antenna fully.

Extend fully.

To Power Outlet

For New Zealand To Single-Line Telephone Jack

Wall Template
8.3 cm