|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Useful Information
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset. Problem w is flashing. Cause & solution L The handset is too far from the base unit. Move closer. L The AC adaptor is not connected. Check the connections. L You are using the handset or base unit in an area with high electrical interference. Place the handset and base unit away from interference sources, such as antennas and mobile phones. L The handset registration is cancelled. Register the handset to the base unit using the following method.
1 2 3 4 5
{j/OK} �SETTING HS� i {>} �REGISTRATION� i {>} �REGISTER HS� i {>} Press and hold {x} on the base unit for about 5 seconds. L If all registered handsets start ringing, press {x} to stop, then start again from step 1. L The rest of the procedure must be completed within 1 minute. i {>}
6 Press {e} or {v} to select a base unit number. 7 Wait until �BS PIN� is displayed. i Enter base
unit PIN (default: �0000�). i {>} L If you forget your PIN, consult your nearest Panasonic service centre. L A confirmation tone will sound, and w will stop flashing. L If w is still flashing, start again from step 1.
The unit does not ring. The handset display is blank. The handset will not turn on.
L The ringer volume is turned off. Adjust the ringer volume (page 11). L The handset is not turned on. Turn the power on (page 6). L Make sure that the batteries are installed correctly (page 6). L Fully charge the batteries (page 6).
17
|
|
|
> |
|
