Tekstowy podgląd strony 102 (kliknij aby zobaczyć)
CHAPTER 5 TROUBLESHOOTING
B. Mechanical system
1. Adjustment at the time of replacement of major parts
Major parts Bin, bin roll Stapler swing unit*1 Lead cam *1 Stapler sorter only. Adjustment 1) Adjustment of bin roll height 2) Adjustment of guide bar parallelism*1 3) Adjusting the Position of the Guide Stopper*1 4) Adjusting the Position of the Load Detecting Switch
Table 5-102 2. Adjusting the bin roll height The dummy roll is designed to be eccentric at the bottom to allow the bin roll height adjustment. The height of touch point between the lead cam end and bin roll can be adjusted. After replacing or changing the positions of the bin rolls, check for the standard dimensions. Change the dummy roll bottom fitting angle if required for adjustment. 1) Adjusting method Keep the bin unit upright, and measure the distance between the dummy roll upper [1] an the bin roll [2]. If the gap is too large, remove the dummy roll lower [3] once and turn it counterclockwise; if the gap is too small, turn it clockwise. Then, mount it so that it is closest to 91.0 mm.
