AEG L50815
Instrukcja Obsługi

Water inlet
Attention! � An inlet hose is supplied and can be found inside the machine drum. � Do not use the hose from your previous machine to connect to the water supply. � This appliance must be connected to a cold water supply. 1. Open the porthole and extract the inlet hose. 2. Connect the hose with the angled connection to the machine. Important! Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. 4. Connect the hose to a tap with a 3/4� thread. Always use the hose supplied with the appliance.

Water Drainage
The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic �U-Piece� supplied. The standpipe should have an internal diameter of approximately 38 mm (see diagram) thus ensuring there is an air break between the drain hose and standpipe. Important! It is essential to lay the drainage hose without kinks.

32