Special spanner A and sealing caps B (2 units) and C (1 unit) come with the appliance. 4. Use special spanner A to remove screw D and the compression spring. 5. Turn sealing cap C upside down as shown in the illustration. 6. Use sealing cap C to cap the hole.
7. Use special spanner A to remove the two screws E. 8. Use special spanner A to remove the four screws F. 9. Remove transit bar G. 10. Screw in the four screws F again. 11. Use sealing caps B to cap the two large holes. Important: Press all sealing caps B (2 items) and C (1 item) in firmly so that they snap into the rear wall.
Where to install
Important! The washing machine must not be operated in a room where there is a danger of frost. There is a risk of frost damage or adverse effect on the perfomance of the machine. Frost damage is not covered under the warranty. � The surface on which the appliance is to be installed must be firm and level. Do not install the appliance on carpeted floors or soft floor coverings. � The surface on which the appliance is to be installed must be clean and dry and free from grease, so that the appliance does not slide. 28
