The SUDS-MISER� System
Your washer has the SUDS-MISER� System. It has two drain hoses One hose moves a portion of used wash water Into a storage tub and moves it back Into the washer for use during the next wash The other hose carries water to another tub with an open drain. or to a standpipe drain If you do not want to re-use wash water for a load, leave the stopper out of the storage tub so the water drains away
SIOUAGE 1UB \ SIANDPIPE SlORAGE WI DRAIN 1UB I
The SUDS-MISER� System stores a portion of the wash water. If you have a storage tub big enough to hold 25 gallons (95 liters) of water, you can have a qualified installer convert your washer to save more of the water.
To sake wash
water
The SUDS-MISER System nor does it save wash
Be sure the stopper IS In the storage tub does not save rinse water from any cycle, water from the PERMANENT PRESS Cycle
To re-use
wash
water
on
1. Set Cycle Control Knob SUDS (see illustration).
2. Pull the Control Knob out. The washer will pump most of the water back from the storage tub into the washer basket.
4. Add about t/2 the recommended amount of detergent 5. Put In the clothes 6. Pull out the Cycle Control Knob to start the washer. 7, Drain the storage tub. Water still in the tub will have any soil that has settled out. The hose is cut on an angle to leave behind about an inch of water and any soil from previous wash.
Do not add clothes at this time. The washer will finish filling with fresh water. 3. When the water has back Into the washer, pumped
push in
the Cycle
Control
Knob.
wash1
I
Off
suds-super
If You want a cycle other than REGULAR HEAVY to follow SUDS, push in the Cycle Control Knob after the water has been pumped back Into the washer. Turn the knob right (clockwlse) to the cycle and wash time you want
