WHIRLPOOL LAT4000AAW
Instrukcja Obsługi

OPERATING
Select Water

INSTRUCTIONS
A WABM wash is a mi�tnre of water from the hot and cold faucets. Rinse water will be cold. Use this for items with moderate amount of soil and eolored items. A COLD wash and rinse is the temperature of water from the cold faucet. Use this setting to minimize fading of brightly colored items and shrinkage of washable woolens. NOTE: Water below 65° F is too eold to dissolve and I activate laundry- detergents. Results maybe poor. ] Soaking To soak heavily soiled or stained items on the Regular or Permanent Press cycle, push in the control knob after the washer has agitated a few mimltes. This will stop the washer and let tile load soak. Generally, soak periods up to 30 minutes are sufficient for most loads (overnight soaking is not necessary or reeommended). When soaking, use up to 50% more detergent OR a presoak product such as BizL To start washing again, pull out the control knob and the washer _41l resume the cycle at the point of interruption. °Brandnames arethe trademarkofthe respective manufacturers.

Level

The pre-set seleetor knob can be set to two distinct settings - PARTIAL and FULL. Turn the selector knob to tbe setting that matches the size of the load. If more water is needed once the fill is complete, move the knob to Reset, then to the desired setting, must circulate freely. If' too little water is used, poor cleaning, linting and results, clothes For best washing exeessi_e wear me) result. Use the billowing as a guide to select the proper water leveh Partial up to I/2 full of clothes Full-l/2 to full of clotbes.

Select
Water

Cycle

and Wash/Rinse
to

Temperature

Push in the cycle control knob and turn clockwise the proper cycle and water temperature,

select the Regular Fabrics cycle when washing towels, sheets, underwear, jeans, etc. The Permanent Press eynle has a shorter spin to minimize wrinkling of permanent press or no iron items. Regular Fabrics Water Temperatures

Start

the

Washer

Cold water waslgcold rinse (up to approximately 8 minutes of wash trine) Warm water wash/cold rinse (approximately 8-12 minutes of wash time) Hot water wash/cold rinse (approximately 13-15 mimltes of wash time) Permanent Press Water Temperature Warm water wash/cokl rinse - 5 to 7 minutes

Pull out the cycle control knob to start the washer. You will hear water entering the wash tnb. Do not move the knob while the washer is operating. Push in the cycle control knob to stop the washer and turn knob clockwise to the desired setting. The washer will panse briefly throughout These pauses are normal. each cycle.

This washer is designed so that it will not agitate or spin when the lid is ()pen. It ,_411, owevel; fill witb the lid h open so water is available fbr pretreating stains or diluting fabric softener. Should the lid be opened during a cycle, the washer will stop; when the lid is closed and the control knob is pulled out, the washer will resume its cycle at the point it was interrupted. NOTE: tf the washer stops during the spin, it maybe due to an unbalanced load. If this happens, push in the control knob, open the lid, redistribute the load, close the lid and pull out the control knob.

When HOT wash is selected, the water x_41lbe the temperature coming from the hot water fhucet. Rinse water w4ll be cold. Use this setting for heavily soiled whites and colorfast items.

PAGE 3