Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
Tuner
Presetting radio stations
You can preset 20 stations for FM and 10 stations for AM.
To set another station to the existing preset number
Start over from step 1. After step 4, press +/� to select the preset number you want to store for another station. You can add a new preset number after the last preset number.
To erase the preset station
1 Press TUNER/BAND repeatedly until
the band you want appears.
Each time you press this button, the band changes as follows: FM y AM
1 Hold down TUNER MEMORY until a preset
number appears.
2 Press TUNING MODE repeatedly until
�AUTO� appears.
3 Press +/� until the frequency indication
starts to change.
DOLBY NR OFF
VOLUME
Scanning stops when the system tunes in a station. �TUNED� and �STEREO� (for a stereo program) appear.
MHz
DOLBY NR OFF
2 Press +/� to select the preset number you
want to erase.
Select �ALL ERASE� when you want to erase all the preset stations.
VOLUME
3 Press ENTER.
�COMPLETE� appears. When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.
To change the AM tuning interval (Except for the European and Middle Eastern models)
The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the ENTER button, turn the power back on. When you change the interval, AM preset stations will be erased. To reset the interval, repeat the same procedure.
Tip
4 Press TUNER MEMORY.
The next available preset number flashes in the display. The stations are stored from preset number 1.
Preset number
DOLBY NR OFF
VOLUME
5 Press ENTER.
�COMPLETE� appears and the station is stored.
6 Repeat steps 1 to 5 to store other
stations. To tune in a station with a weak signal
The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
Press TUNING MODE repeatedly until �MANUAL� appears in step 2, then press +/� to tune in the station.
