SHARP LC-26GA4E
Instrukcja Serwisowa

Preparation

LC-26GA4E

Inserting the batteries Simple operations for watching a TV programme

Before using TV for first time, insert two �AAA� size (supplied). When the batteries become Basic connection depleted and remote control fails to operate, replace the batteries with new �AAA� size batteries.

Connecting to an antenna
antenna with a coaxial cable.

1 Press and slide the battery cover open it. To enjoy clearer picture, use outdoor antenna. The following is a brief explanation of connecting to an

2 Insert two supplied �AAA� size batteries.

� Place batteries with their terminals corresponding to

and ( ) indications in the batter y compartment.

3 Close the battery cover.

CAUTION

Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below. � Do not mix types. Different types of batteries have different characteristics. � Do not mix batteries. Mixing old and can shorten the life of new batteries or cause chemical leakage in old batteries. � Remove soon as they have worn out. Chemicals that leak from batteries can cause a rash. If you find any chemical leakage, wipe thoroughly with a cloth. � The batteries supplied with this product may have a shorter life expectancy due to storage conditions. � If you will not be using remote control unit for an extended period of time, remove the batteries from it.

Using the remote control unit

Use control unit by pointing it towards the remote sensor window. Objects between the remote control unit and sensor window may prevent proper operation.

7m

30 30

23

fe

et

8
(IEC 169-2), plug it into IN terminal at rear of the TV. � Do not install or place the remote control unit under direct sunlight. Remote control sensor

Cautions regarding remote control unit

� Do not expose the remote control unit to shock. Antenna cables�commercially available

In addition, expose the remote control unit to liquids, and do not place in an area high humidity. If your outdoor antenna uses 75-ohm coaxial cable with a standard DIN45325

The heat may cause deformation of the unit.

� The control unit may not work properly if the remote sensor window of

the Display is under direct sunlight or strong lighting. In such case, change angle of lighting Display, or operate the remote control unit closer to the remote sensor window.