WHIRLPOOL LLT7144DQ0
Instrukcja Obsługi

Caring
Cleaning
Exterior

for Your Washer
your washer
Interior
Clean interior with 1 cup (250 mL) of chlorine bleach mixed with 2 cups (500 mL) of detergent. Run washer through a complete cycle using hot water. Repeat process if necessary. NOTE: Remove hard water deposits using only cleaners labeled as washer safe.

Proper care of your washer can extend its life. This section explains how to care for your washer properly and safely.

Wipe up detergent, bleach, and other spills with a soft, damp cloth or sponge as they occur. Occasionally wipe the outside of the �. washer to keep it looking like liiiil new. Do not put sharp or metal objects in your washer. They can damage the finish. Check all pockets for pins, clips, money, bolts, nuts, etc. Do not lay these objects on your washer after emptying pockets.

Winter

storage

or moving

care

Install and store your washer where it will not freeze. Because some water may stay in the hoses, freezing can damage your washer. If storing or moving your washer during freezing weather, winterize it. To winterize washer: To use washer again: 1. Shut off both water faucets. 1. Flush water pipes and hoses. 2. Disconnect and drain water inlet hoses. 2. Reconnect water inlet hoses. 3. Put 1 quart (1 L) of R.V.-type antifreeze in 3. Turn on both water faucets. the basket. 4. Reconnect power supply cord. 4. Run washer on a drain and spin setting 5. Run the washer through a complete cycle (see page 8) for about 30 seconds to mix with 1 cup (250 mL) of detergent to clean the antifreeze and water. out antifreeze. 5. Unplug the power supply cord.

Non-use

or vacation

care
l

Operate your washer only when you are at home. If you will be on vacation or not using your washer for an extended period of time, you should: l Unplug the power supply cord or turn off electrical power to the washer.

Turn off the water supply to the washer. This helps avoid accidental flooding (due to a water pressure surge) while you are away.

11