|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
LT-1/LT-1B
3 ADJUSTMENTS AND CHECKS
3-1 TUNER SECTION
Use a screwdriver with a plastic or ceramic grip for all adjustment.
3-1-1 AM adjustment
1. Set the function switch to the TUNER position. 2. Set the BAND switch to the AM position. 2. Connect the test loop antenna across the output of the signal generator. 3. Connect the oscilloscope to the PHONE JACK terminal. 4. Set the signal generator as listed in the alignment chart.
3-1-2 FM adjustment
1. Set the function switch to the TUNER position. 2. Set the BAND switch to the FM position. 3. Connect the signal generator output through a 75 ohm dummy antenna to "ANT" on TUNER PCB.CN8. 3. Connect the oscilloscope to the PHONE JACK terminal. 4. Set the signal generator as listed in the alignment chart.
3-2 Adjustment and Test Points
LT-1 TUNER PCB
L3
TC1
AM ANT COIL
L5
L4
CN8
TUNER
Fig. 3-2-1
4
|
