1.1 Unpacking Check for the following items: � verify the model number � power cord � Installation Instructions
AUDIO A and AUDIO B terminals (RCA connector) on the rear panel. When selected, the respective indicator lights.
3
Volume buttons [VOLUME
]
1.2 Monitor The LTC 2810/90 is a multi-standard color monitor housed in a metal cabinet for rugged reliability. It has a 10-inch tube (viewable picture area 23 cm (9")). The monitor offers simple adjustments to meet particular requirements, with default parameters set at the factory. With a built-in loudspeaker and inputs able to accept NSTC and PAL standards, the monitor offers a flexible solution for a wide variety of surveillance application. 1.3 Power
Voltage Power at range (VAC) Rated V. 90 to 260 50 W Sync Format NTSC/PAL
These buttons have two functions: Volume control: Press the + or - buttons as required to adjust the speaker volume. Data controls: When the SHARP, TINT, COLOR, BRIGHTNESS and CONTRAST buttons are pressed, used to change the value of the selected function.
4
Contrast button [CONTRAST
]
Press this button to adjust picture contrast. Adjust the value with the VOLUME buttons to control the image contrast (Default is 60).
5
Brightness button [BRIGHTNESS
]
Model No.
Rated Voltage LTC 2810/90 100/240 VAC, 50/60 Hz
Press this button to adjust picture brightness. Adjust the value with the VOLUME buttons to control the image brightness (Default is 50).
6
Color button [COLOR
]
The monitor is delivered with a 2-pole Euro cord and a 3-pole US cord.
Press this button to adjust the picture color intensity. Adjust the value with the VOLUME buttons to control the image color (Default is 50).
7
2
2.1
1
CONTROLS AND FEATURES
Front Panel Power switch [POWER ]
Tint button [TINT
] (NTSC only)
Press this button to control the picture color to be close to nateral color. Adjust the value with the VOLUME buttons to control the color tint (Default is 50).
8
Press this switch to turn the power ON or OFF.
2
Video button [VIDEO
]
Sharp button [SHARP
]
Selects the composite video signal inputs to the VIDEO A (Green LED indication) and VIDEO B (Orange LED indication) terminal and the audio signal input to the
Press this button to adjust the picture image. Adjust the value using the VOLUME buttons to control the sharpness of the image (Default is 50).
